What Does C1730 Mean?
The 5-volt reference voltage supplied by the chassis control module to one or more sensors is out of its expected range. This reference voltage is critical for ride height sensors, steering angle sensors, and other chassis components. When this voltage drifts outside specification, multiple sensor readings become inaccurate, potentially causing cascading faults across the suspension and stability control systems.
Common Causes
35%
One or more sensors on the shared 5V reference circuit has an internal short, dragging the reference voltage down or pulling it up
25%
Wiring short in the 5V reference circuit — short to ground pulls voltage low, short to battery pulls it high
20%
Faulty chassis control module with degraded internal 5V voltage regulator
15%
Corroded connector at a sensor or module causing high-resistance connection that drops the reference voltage
5%
Water intrusion into a connector or module housing affecting the reference circuit
Diagnostic Steps
1
Measure the 5V reference voltage at the module connector and at each sensor connector on the circuit — should be 4.9-5.1V. Note where the voltage deviates from spec.
2
Disconnect sensors one at a time while monitoring the 5V reference voltage — if the voltage returns to normal when a specific sensor is disconnected, that sensor is shorting the reference line.
3
With all sensors disconnected, measure the reference voltage at the module output — if still out of range, the module's internal regulator is faulty.
4
Check for corrosion at all connectors on the 5V reference circuit, especially sensors located in exposed underbody locations prone to water and salt spray.
5
Inspect the wiring harness for damage between the module and all sensors sharing this reference circuit, particularly at routing points near heat sources and moving components.
Estimated Repair Cost
$100 - $900
Parts + labor, varies by vehicle and location
The 5-volt reference voltage supplied by the chassis control module to one or more sensors is out of its expected range. This reference voltage is critical for ride height sensors, steering angle sensors, and other chassis components. When this voltage drifts outside specification, multiple sensor r...
The most common cause of C1730 (Reference Voltage Out of Range (+5 v)) is: One or more sensors on the shared 5V reference circuit has an internal short, dragging the reference voltage down or pulling it up
Typical repair costs for C1730 range from $100 to $900, depending on the vehicle, location, and whether you do it yourself or go to a shop.
The vehicle can be driven cautiously. Multiple chassis systems may be affected including suspension leveling and stability control. Sensor-dependent safety systems may not function correctly. Limit speed and avoid aggressive driving. Repair promptly as this fault can cascade to affect multiple systems.
Start by connecting an OBD2 scanner to read the code and any freeze frame data. Then follow the diagnostic steps specific to C1730 to identify the root cause.
OBDHut Mobile App
Scan codes directly from your car with the OBDHut app.
Coming Soon
Quick Info
Category
Chassis
System
Chassis Electronics / Sensor Reference
Difficulty
Type
Manufacturer
Recommended Tools
OBD2 Scanner
A quality scan tool helps you read codes, view live data, and clear faults.
