What Does P0905 Mean?
The TCM has determined that the gate select position sensor signal is out of the expected operating range or is not performing within specification. Unlike a simple circuit fault, this code indicates the sensor is providing a signal, but the readings do not correspond to known gate positions or the signal transitions are erratic. This may indicate a worn or misaligned sensor.
Safety Warning
Erratic gate position readings can cause the TCM to attempt incorrect gear selections, leading to gear clashing or unexpected shifts. Do not drive until diagnosed and repaired.
Common Causes
35%
Worn or contaminated gate select position sensor producing erratic output
25%
Mechanical misalignment of the gate select linkage or sensor mounting
25%
Intermittent wiring connection causing signal dropout or spikes
15%
TCM calibration issue or software requiring update
Diagnostic Steps
1
Step 1: Using a scan tool, monitor the gate select position sensor voltage in real time while cycling through gate positions — look for dead spots, voltage spikes, or inconsistent readings.
2
Step 2: Inspect the mechanical alignment of the gate select sensor on the transmission — verify the sensor is properly seated and the linkage has no excessive play or worn bushings.
3
Step 3: Wiggle-test the wiring harness and connector while monitoring sensor voltage — any signal dropout or spike indicates an intermittent connection.
4
Step 4: Verify the sensor output voltage range matches manufacturer specifications at each gate position (typically distinct voltage steps for each gate).
5
Step 5: Check for any TSBs or software updates for the TCM that address gate select sensor calibration or range parameters.
Estimated Repair Cost
$150 - $700
Parts + labor, varies by vehicle and location
The TCM has determined that the gate select position sensor signal is out of the expected operating range or is not performing within specification. Unlike a simple circuit fault, this code indicates the sensor is providing a signal, but the readings do not correspond to known gate positions or the ...
The most common cause of P0905 (Gate Select Position Circuit Range/Performance) is: Worn or contaminated gate select position sensor producing erratic output
Typical repair costs for P0905 range from $150 to $700, depending on the vehicle, location, and whether you do it yourself or go to a shop.
Erratic gate position readings can cause the TCM to attempt incorrect gear selections, leading to gear clashing or unexpected shifts. Do not drive until diagnosed and repaired.
Start by connecting an OBD2 scanner to read the code and any freeze frame data. Then follow the diagnostic steps specific to P0905 to identify the root cause.
OBDHut Mobile App
Scan codes directly from your car with the OBDHut app.
Coming Soon
Quick Info
Category
Powertrain
System
Automated Manual Transmission (Shift Control)
Difficulty
Type
Generic (SAE)
Recommended Tools
OBD2 Scanner
A quality scan tool helps you read codes, view live data, and clear faults.
