What Does U0175 Mean?
Communication has been lost between the airbag control module and restraint system sensor F. This network communication failure prevents proper crash detection from this sensor's monitoring zone.
Safety Warning
Critical safety system malfunction compromising airbag deployment capability. Vehicle operation is unsafe until system is fully operational and fault is cleared.
Common Causes
35%
Failed impact sensor F due to internal component degradation or environmental damage
30%
Damaged or severed wiring between sensor F location and airbag control module
20%
Ground connection failure at sensor F mounting or harness ground point corrosion
10%
CAN bus communication circuit fault (open circuit, short circuit, or high resistance)
5%
Airbag control module internal failure affecting sensor F communication port
Diagnostic Steps
1
Step 1: Identify sensor F position from service documentation and inspect sensor, mounting bracket, connector, and surrounding area for damage or contamination
2
Step 2: Verify proper voltage supply (typically 5V) at sensor F connector and test ground circuit for less than 0.5 ohm resistance to known good ground
3
Step 3: Check CAN high and CAN low communication lines for proper impedance between them and verify no shorts to voltage or ground exist
4
Step 4: Trace wiring harness from sensor F to control module checking for damaged insulation, broken wires, or corroded splice connections
5
Step 5: Clear codes and test drive to verify intermittent fault; if fault returns immediately, replace sensor F after confirming circuit integrity
Estimated Repair Cost
$150 - $700
Parts + labor, varies by vehicle and location
Communication has been lost between the airbag control module and restraint system sensor F. This network communication failure prevents proper crash detection from this sensor's monitoring zone.
The most common cause of U0175 (Lost Communication With Restraints System Sensor F) is: Failed impact sensor F due to internal component degradation or environmental damage
Typical repair costs for U0175 range from $150 to $700, depending on the vehicle, location, and whether you do it yourself or go to a shop.
Critical safety system malfunction compromising airbag deployment capability. Vehicle operation is unsafe until system is fully operational and fault is cleared.
Start by connecting an OBD2 scanner to read the code and any freeze frame data. Then follow the diagnostic steps specific to U0175 to identify the root cause.
OBDHut Mobile App
Scan codes directly from your car with the OBDHut app.
Coming Soon
Quick Info
Category
Network
System
Supplemental Restraint System (SRS/Airbag)
Difficulty
Type
Generic (SAE)
Recommended Tools
OBD2 Scanner
A quality scan tool helps you read codes, view live data, and clear faults.
