OBDHut

OBDHut

P2795

Moderate

Gear Shift Direction Circuit High

What Does P2795 Mean?

The transmission control module has detected voltage in the gear shift direction circuit that exceeds the normal operating range. This high voltage condition interferes with proper gear direction selection.

Common Causes

35%

Shift direction sensor signal wire shorted to voltage source

Transmission Wiring Harness
Sensor Signal Wire

30%

Failed shift direction sensor with internal short to power

Shift Direction Sensor
Manual Valve Position Sensor

20%

Damaged wiring harness with chafed insulation causing short

Transmission Wiring Harness
Protective Conduit

10%

Transmission control module internal failure creating voltage spike

Transmission Control Module

5%

Aftermarket electrical accessories causing voltage backfeed

Wiring Harness
Electrical Accessories

Diagnostic Steps

1

Step 1: Disconnect shift direction sensor and measure voltage on signal wire from TCM (should drop to near zero)

2

Step 2: Inspect wiring harness routing for areas where wires may contact hot circuits or sharp edges

3

Step 3: Test sensor for internal short by measuring resistance between signal terminal and power supply terminal

4

Step 4: Check for voltage on signal circuit at TCM connector with sensor disconnected

5

Step 5: Monitor signal voltage with oscilloscope during operation to detect intermittent shorts

Estimated Repair Cost

$175 - $1,100

Parts + labor, varies by vehicle and location

Frequently Asked Questions

What does P2795 mean?

The transmission control module has detected voltage in the gear shift direction circuit that exceeds the normal operating range. This high voltage condition interferes with proper gear direction selection.

What causes P2795?

The most common cause of P2795 (Gear Shift Direction Circuit High) is: Shift direction sensor signal wire shorted to voltage source

How much does it cost to fix P2795?

Typical repair costs for P2795 range from $175 to $1,100, depending on the vehicle, location, and whether you do it yourself or go to a shop.

Is it safe to drive with P2795?

May cause transmission to select wrong gear direction or enter limp mode. Could potentially engage reverse when forward is intended, creating dangerous situation.

How do I diagnose P2795?

Start by connecting an OBD2 scanner to read the code and any freeze frame data. Then follow the diagnostic steps specific to P2795 to identify the root cause.

OBDHut Mobile App

Scan codes directly from your car with the OBDHut app.

Coming Soon

Quick Info

Category

Powertrain

System

Transmission Control System

Difficulty

Moderate

Type

Generic (SAE)

Recommended Tools

OBD2 Scanner

A quality scan tool helps you read codes, view live data, and clear faults.